2n M2M Solution 2N SmartCom - User Manual 1.9.0 Manual do Utilizador descarregar pdf (Página 38)

382N TELEKOMUNIKACE a.s., www.2n.cz

Enter the command to change the status of relay 2. The relay will be in the

position as before restart after the terminal restart.

at^screl2=1

Enter the command to change the status of relay 2.

at^screl2=1,0

Enter the command to change the status of relay 2. The relay will be in the

opposite position after restart.

at^screl2=1,1

Enter the command to change the status of relay 2. The relay will be in this

position after restart.

at^screl2=1,2

Enter the command to change the status of relay 2. The relay will be in the

position as before restart after the terminal restart.

ADC – Input Circuits

These commands help control the input circuits, set calibration and make

measurements.

at^scadc1="get_value"

Enter the command to measure the value of the selected port and send the

measured value.

at^scadc1="adc_value"

Enter the command to make the measurement and return the A/D converter

value.

at^scadc1="calib_min"

Enter the command to make automatic port calibration according to the currently

measured value.

at^scadc1="calib_max"

Enter the command to make automatic port calibration according to the currently

measured value.

at^scadc1="threshold_low",200

Manual calibration setting (minimum values). Setting options: 0 – 960.

at^scadc1="threshold_high",250

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 148 149

Sem comentários

2n M2M Solution 2N SmartCom - User Manual 1.9.0 Manual do Utilizador Página 38