2n M2M Solution 2N SmartCom - User Manual 1.9.0 Manual do Utilizador descarregar pdf (Página 55)

552N TELEKOMUNIKACE a.s., www.2n.cz

SC Ping

These commands are available in the and vers2N SmartCOM

2N SmartCOM

PRO

ions only. Enter the commands to set periodical pinging to the set address in defined

intervals. Use SC Ping to ensure the correct function of NFG syntax in UDF or keep

firewall connection if the terminal is in the STANDALONE mode.

at^scping="host","8.8.8.8"

Enter the command to set the Host IP address to which the ICMP request shall be

sent.

at^scping="interval",5

Enter the interval in minutes. 0 means that periodical pings are deactivated.

at^scping="test"

Enter the 'test' command to test configuration before saving. The currently

changed value is always saved and thus no restart is needed during setting and

functionality check.

at^scping="save"

Enter the command to save the changes.

at^scping="restart"

Enter the command to restart the function.

at^scping="srestart"

Enter the command to save the changes and reset the ping parameters

immediately.

at^scping?

Enter the command to display the current interface values.

SCPING: "HOST","8.8.8.8"

SCPING: "INTERVAL",0

at^scping=?

Enter the command to display the interface setting options.

SCPING: "HOST","1-32"

SCPING: "INTERVAL",0-65534

SCPING: "TEST"

SCPING: "SAVE"

SCPING: "RESTART"

SCPING: "SRESTART"

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 148 149

Sem comentários

2n M2M Solution 2N SmartCom - User Manual 1.9.0 Manual do Utilizador Página 55